Star Micronics TSP2000 Manual do Utilizador descarregar pdf (Página 17)

– 13 –

ENGLISH

(5)If the power switch is set to OFF, set it to ON to turn on the printer. Make sure

that the ERROR LED is not lit.

Note: While the ERROR LED is lit, the printer will not accept any commands

such as the print command, so make sure that the printer cover is locked

properly.

(6)Once the printer cover is locked, the paper end will be ejected and the end cut

off automatically.

5-2. Removing Remaining Paper

(1)Pull the lever toward you to open the printer cover.

Note: Make sure that the lever is pulled until it stops at the stopper. If the lever

is not pulled up to the stopper, the printer cover may not open.

(2)Remove the remaining paper.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 102 103

TSP2000 SERIES 1
Trademark acknowledgments 2
TABLE OF CONTENTS 3
3-1. Interface Cable 8
Serial interface cable 9
Parallel interface cable 9
Ferrite core (17.5 mm wide) 10
Connector 10
One loop 10
Pull and cut 11
Fastener 11
3-4. Turning Power On 13
4. Control Panel 14
5. Loading Paper 15
5-2. Removing Remaining Paper 17
6. Near-end Sensor 18
Approx. ø26 mm Level 2 (top) 19
7-1. Preventing Paper Jams 20
7-2. Removing Paper Jam 20
Auto cutter 21
Front cover 21
Check window 22
Moving blade 22
8. Test Print Method 23
9. Periodical Cleaning 24
TABLE DES MATIERES 25
FRANÇAIS 26
Emplacement de l’imprimante 27
3-1. Câble d’interface 29
POWER ERROR FEED 35
5. Chargement du papier 36
5-2. Retrait du papier 38
6. Capteur de fin de rouleau 39
8. Test d’impression 44
9. Nettoyage 45
INHALTSVERZEICHNIS 47
3. Anschlußkabel und Netzteil 51
Serielles Schnittstellenkabel 52
Ferritkern (17,5 mm breit) 53
Modularstecker 53
Eine Schleife 53
Ziehen und 54
Kabelbinder 54
3-4. Einschalten 56
5. Einlegen von Papier 58
6. Papiervorrat-Sensor 61
Schraubenposition 62
Ca. ø22 mm Position 1 (unten) 62
Ca. ø26 mm Position 2 (oben) 62
7-2. Beheben von Papierstau 63
Automatisches Schneidmesser 65
Frontabdeckung 65
Prüffenster 65
Bewegliche Klinge 65
8. Testdruck-Verfahren 66
9. Regelmäßige Reinigung 67
ITALIANO 70
3-1. Cavo interfaccia 73
3-4. Accensione 78
5. Caricamento della carta 80
8-2. Scaricamento esadecimali 88
9. Pulizia periodica 89
Appendix A: Specifications 91
A-2. Print Specifications 92
A-4. Interface 92
A-5. Power Supply 92
A-7. Reliability 93
APPENDIX 94
B-1. Serial Interface Type 95
2 3 4 5 6 7 8 96
During Reverse mode 98
13 12 11 10 9 8 7 6 5 4 3 21 100
D-2. Cable Connections 101
Wire lead 102
OVERSEAS SUBSIDIARY COMPANIES 103
STAR MICRONICS AMERICA, INC 103
STAR MICRONICS U.K. LTD 103
ELECTRONIC PRODUCTS DIVISION 103
STAR MICRONICS CO., LTD 103

Comentários a estes Manuais

Sem comentários

Star Micronics TSP2000 Manual do Utilizador Página 17

Comentários a estes Manuais

Manuais e produtos relacionados com Digitalizar e Imprimir Star Micronics TSP2000