Star Micronics SP2000 Manual do Utilizador descarregar pdf (Página 41)

*1: Comdex Dual Auto Cut Mechanism (STAR mode only)

This mechanism automatically cuts when there is a consecu-

tive paper feed exceedin 7/6 inch. Hosts that cannot send an

escape sequence such as <ESC> “d” and 0, can cut the

paper if a line feed code <LF> of 1/6 inch is sent 7 times

consecutively.

N = 2 (ESC/POS mode)

: Always “0”

Parameter Setting “0” to “F”

Paper near end See below

sensor

4) N = 3 (Star mode)

: Always “0”

Parameter Setting “0” to “F”

Character table

Character table See below

CR code

n4 Paper near end sensor

“0” or “4” or “8” or “C” Invalid

“1” or “9” or “D” Invalid

“2” or “A” or “E” Reflects status of sensor to STATUS

and when near end, does not go offline

and does not stop printing.

“3” or “B” or “F” Reflects status of sensor to STATUS

and when near end, goes offline and

stops printing.

n4 Comdex dual auto-cutter

“0” to “7” Invalid

“8” to “F” Valid

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 80 81

Sem comentários

Star Micronics SP2000 Manual do Utilizador Página 41