Star-micronics TCP400 Series Manual do Utilizador descarregar pdf (Página 34)

– 31 –

Appendix C: Optional Ethernet Interface IFBD-HE05

To initialize the setting information, set the push switch as described below.

Push the switch for 1 to 5 seconds while the unit is operating in the normal mode. The

greenandredLEDswillashwitharegularpattern.

In this state, momentarily push the switch once again to turn OFF both the green and

red LEDs. This will revert the interface board to its factory settings. After the interface

board has been initialized, the unit will automatically reboot itself.

Green(100M):Lightswhentheportisoperatingat100Mbps.

Red(Link/Activity):Lightswhenthelinkismadebetweentheportandtheconnected

device, and mutual communication is enabled.

1. An Ethernet cable is not included with the unit. Please provide a cable that is

appropriate for the specs.

2. To prevent electromagnetic interference, attach the supplied ferrite core, which is

supplied with the Ethernet board, to the cable.

3. For details on how to attach the ferrite core, see the installation sheet that is

supplied with the Ethernet board.

4. Insert the Ethernet cable into the interface board connector.

Push switch

LED

Push switch

1 2 ... 29 30 31 32 33 34 35 36

Sem comentários

Star-micronics TCP400 Series Manual do Utilizador Página 34